Glock 19 assist needed
Hi all, I'm a newbie on the forum, though I have been an IDPA member since the year it was started. I brought a brand new Gen4 Glock 19 home about a ...Read More
View ArticleRe: Glock 19 assist needed
Load the mags to capacity and leave them for a couple of weeks, then shoot them dry, do it again and when you try them next, load the extra round and all should be OK.
View ArticleRe: Glock 19 assist needed
+1 on the mag conditioning but I have a question. Are you using 10 round capacity mags? If so, how are you loading the 11th round?
View ArticleRe: Glock 19 assist needed
Thanks for the replies, I'll try conditioning the mags.ajackb, I am using 10 round mags, loading the initial round in the chamber with a spare mag then changing out with a full mag.BillRead More
View ArticleRe: Glock 19 assist needed
Make sure that the spring on the slide stop is under the locking block pin. It often is misplaced when working on a Glock.
View ArticleRe: Glock 19 assist needed
Nope, made sure of that one, everything is in place, and functions perfectlytill I add the 11 round. I stopped at my local Glock shop today and their opinion is the same as above, the mags need some...
View ArticleRe: Glock 19 assist needed
I think you need to load your first round out of the magazine, not drop load into the chamber, then change magazines to a fully loaded 10 rounder. Bet this solves your problem.Arlin
View ArticleRe: Glock 19 assist needed
Arlin Gurley wrote:I think you need to load your first round out of the magazine, not drop load into the chamber, then change magazines to a fully loaded 10 rounder. Bet this solves your problem.Read...
View ArticleRe: Glock 19 assist needed
Hi Bill, I'm wondering if the following is happening? You load the mag, rack the slide chambering a round, drop the mag to replace the chambered cartridge. My question, is the topped off mag placing...
View ArticleRe: Glock 19 assist needed
Jim, I believe your assessment is probably correct, but no matter where the dragis applied, the overly high tension of the new mag springs seems to be the root issue.I followed the advice of Repete...
View Article
More Pages to Explore .....